ARAGORN 450 SC

Explanation
PREPARATION OF THE PLANT PROTECTION PRODUCT FOR APPLICATION:

The plant protection product calculated over the recommended dosage is first mixed with some water in a separate container. The tank of the application machine is half filled with water. While the mixer of the machine is running, mixed water is added to the tank. The mixing is continued and the tank is completed with water. Mixing process continues until the application is completed. Use the prepared plant protection product on the same day. The amount of water to be used per da should be 20-40 liters, and fan jet nozzle should be used in applications.

Calibration:

Before the application, the calibration of the application machine should be done.
Mixing amount should be adjusted to provide a good coating in applications. Applications should be done in cool hours of the day in windless or less windy weather conditions.

CLEANING OF THE APPLICATION MACHINE:

Empty the application machine's tank safely immediately after the application is completed. After filling the tank with clean water, run the mixer and spray system to ensure all parts are washed. Do not wash near water sources. Do not discharge washing water and wastes into water sources.

HOW TO USE THE PLANT PROTECTION PRODUCT

Pre-emergence application: 1-2 days after planting. During the application, the soil should be without dummy. No soil cultivation should be done for at least 20 days in the application area. In clay and organic matter-rich soils, application can be done at higher doses. Care should be taken when using the product in very light and sandy permeable soils and a low dose should be preferred.

Post-emergence application: It should be done in the young periods of weeds. There is no accumulation in the soil. It breaks down in the soil by microorganisms within a few months. Therefore, it will not be harmful to the cultivated plant that is planted in the following year.

INFORMATION ABOUT RESISTANCE

Plant protection product named ARAGORN 450 SC is a Herbicide classified as Group C: 2 according to its mechanism of action. Repeated applications of plant protection products with the same mechanism of action promote resistance development. For this reason, in order to delay resistance development, do not exceed total application number of ARAGORN 450 SC in the same season. In cases where the application should be repeated, pay attention to the use of plant protection products with a different mechanism of action (other than Group C: 2).

MIXTURE STATUS

ARAGORN 450 SC can be mixed with many other weed plant protection products. However, we recommend the farmer to try a premix at his own expense and responsibility. It cannot be mixed with the estered formulations of hormone plant protection products.

• Read the label first.
• Do not use at home
• Keep away from children, food and animal feeds.
• Do not eat, drink or smoke during the application of the plant protection product.
• Do not let people and animals enter the area where plant protection products are applied for 7 days.
• To prevent risks to human and environmental health, use as recommended and at the recommended dosage.
• It is strictly forbidden to use other than the recommended products.

Rinse well by putting clean water up to ¼ in the empty packages of the product used. Pour the rinse water into the application tank. Repeat this process 3 times.

POISONING SYMPTOMS

General signs of poisoning may appear. Headache, dizziness, vomiting, etc.

FIRST AID MEASURES

After Inhalation: Move patient to fresh air. If breathing is irregular or stopped, administer artificial respiration. Keep the patient in a warm and comfortable place. Call a doctor or poison information center immediately.

After Skin Contact: Immediately take off contaminated clothing. Wash the body parts touching the product with plenty of water and soap for 15-20 minutes. If skin irritation persists, call a doctor. Wash contaminated clothing before using it.

After Eye Contact: Immediately wash the eyes and under the eyelids with plenty of water for 15 minutes. Remove contact lenses, if present. Get medical attention immediately.

After Swallowing: If swallowed, seek medical advice with the product label or this information form. Never give anything by mouth to an unconscious patient and do not force them to induce vomiting.

ANTIDOTE and TREATMENT

It has no special antidote. Treat symptomatically and supportive therapy.

NATIONAL POISON CENTER (UZEM) WIRE

CONTENTS

linuron
HAZARDOUS EXPRESSIONS (H)

H302: Harmful if swallowed.

H351: Suspected of causing cancer.

H360Df: May damage the unborn child. Suspected of damaging fertility.

H373: May cause damage to organs through prolonged or repeated exposure.

H400: Very toxic in the aquatic environment.

H410: Long-lasting, very toxic effect in the aquatic environment.

Precautionary Statements (P)

P201: Read special instructions before use.

P202: Do not handle until all precautionary statements are read and understood.

P273: Avoid release to the environment.

P280: Wear protective gloves / protective clothing / eye protection / face protection.

P305 + P351 + P338: IF IN EYES: Rinse carefully with water for several minutes. Remove contact lenses if fitted and easy to do. Continue rinsing.

P391: Collect spillages.

P405: Store locked up.

P501: Dispose of contents / container in accordance with local regulations.

EUH401: Follow the instructions for use to avoid risks to human health and the environment.

MATTERS TO BE CONSIDERED WHEN USING AND STORING

• It is poisonous to the fish. Avoid contaminating underground and groundwater.
• It is poisonous to bees. Do not use during the flowering period.
• Do not apply in windy weather.
• Be careful not to infect neighboring cultivars.
• Do not open clogged adapters by blowing them, clean them with a brush.
• Wash the equipment used in the application thoroughly with soap and soda water before using in other combat jobs.
• Do not put plant protection products in empty food and beverage cans.

STORAGE STATUS

When stored unopened in its original packaging under normal (cool and dry) conditions, there is no change in the physical, chemical and biological properties of the product for 2 years outside the tolerance limits.

COMPANY STATEMENT

The manufacturers guarantee the quality of plant protection products provided that they are sold in their original packaging. Manufacturers do not accept responsibility for any damage caused by improper storage of plant protection products or deficiencies in following recommendations.

LICENSE OWNER AND MANUFACTURER COMPANY

ERTAR KİMYA Agricultural Products Tools Manufacturing Market. Singing. ve Tic. Ltd. Sti.

Acıdere OSB Mah. Zafer Cad. No: 8 Saricam / ADANA

Tel: 0 (322) 456 19 44 Fax: 0 (322) 456 19 47

info@ertarkimya.com.tr www.ertarkimya.com.tr

PLANTS AND FOREIGN HERBS WHICH IT IS USED