PREPARATION OF PLANT PROTECTION PRODUCT FOR APPLICATION:
The plant protection product calculated over the recommended dosage is first mixed with some water in a separate container. The sprayer tank is half filled with water. While the mixer of the machine is running, the mixture is added to the tank. The mixing is continued and the tank is completed with water. Mixing process continues until the application is completed. The amount of water to be used per decare should be 20-40 liters, and fan jet nozzle should be used in applications. The prepared mixture should be used on the same day. Applications should be done in cool hours of the day, in windless or less windy weather conditions.
Calibration of the sprayer must be done before the application. The tank of the sprayer is filled with water to determine the amount of water to be used per decare. With this water, how much area is wetted is determined and the amount of water to be used in the application is calculated.
CLEANING OF THE SPRAYING MACHINE:
Empty the sprayer tank safely immediately after the application is completed. After filling the tank with clean water, run the mixer and spray system to ensure that all parts are washed. Do not wash near water sources. Do not discharge washing water and wastes into water sources.
HOW TO USE THE PLANT PROTECTION PRODUCT:
The best effect in MANTRAK applications is taken from applications when the true leaves of weeds are seen, in rapid growth and when their tops are not covered by cereals.
Cereals (Wheat, barley): It is used in the period from the period when weeds complete the exit of the weeds until the end of the brooding period of cereals. If it is used after the circuit in which the cereals have stalked, the desired effect cannot be obtained and is not recommended. Do not apply after frost or if there is an expectation of night frost.
Corn: It is used in the period when the corn plant completes the emergence of weeds with 3-5 leaves. During and after application (7-10 days), if the average daily temperature rises above 15 ° C, neighboring cultivars with large leaves can be damaged. Therefore, it is not recommended to use it in Mediterranean, Southeastern Anatolia and Aegean Regions where the temperature is high during this period.
Plant protection product named MANTRAK is a herbicide classified as Group O, 4 + B, 2 according to its mechanism of action. Repeated applications of plant protection products with the same mechanism of action promote resistance development. For this reason, in order to delay the development of resistance, do not exceed the total number of applications of MANTRAK recommended in the same production season. In cases where the application should be repeated, pay attention to the use of plant protection products with different mechanism of action (Group O, 4 + B, 2 external).
It can be applied by mixing with narrow-leaf herbicides with products containing Fenoxaprop-p-ethyl. It is not recommended to mix with other narrow leaf herbicides. It can be applied by mixing with EFOLAM 22 E. It can be applied by mixing with nitrogen, phosphorus and potassium compound leaf fertilizers. It is recommended to make preliminary mixture tests before making a large amount of mixture for application.
Rinse well by putting clean water up to ¼ in the empty packages of the product used. Pour the rinse water into the application tank. Repeat this process 3 times.
Nausea, sweating, headache, dizziness, drowsiness. May cause skin and eye irritation.
FIRST AID MEASURES
After Inhalation: Remove person to fresh air; if not breathing, give artificial respiration after calling the emergency center or ambulance. If artificial respiration is to be made from mouth to mouth, the practitioner should use rescuer protection (pocket mask etc.) Consult the poison control center or doctor for treatment recommendations.
After Skin Contact: Immediately take off any contaminated clothing. Wash the body parts of the medicine with plenty of water and soap for 15-20 minutes. If skin irritation persists, call a doctor. Wash contaminated clothing before using it.
After Eye Contact: Shake the eyes open for 15-20 minutes in water with slow and gentle movements. After the first 5 minutes, continue removing the lenses and shaking the eyes, if any. Contact a poison control center or doctor for treatment advice.
After Swallowing: If swallowed, seek medical advice with the product label or this information form. Never give anything by mouth to the unconscious patient and do not force them to vomit.
NATIONAL POISON CENTER (UZEM) TEL: 114
ANTIDOTE and TREATMENT
It has no special antidote. Treatment is applied according to the symptoms.
2,4-D Ethylhexyl Ester
HAZARDOUS EXPRESSIONS (H)
H302: Harmful if swallowed.
H317: Causes allergic skin reactions.
H318: Causes serious eye damage.
H319: Causes serious eye irritation.
H400: Very toxic in the aquatic environment.
H410: Long-lasting, very toxic effect in the aquatic environment.
Precautionary Statements (P)
P261: Avoid breathing spray.
P273: Avoid release to the environment.
P280: Wear protective gloves / protective clothing / eye protection / face protection.
P302 + P352: IF ON SKIN: Wash with plenty of soap and water.
P305 + P351 + P338: IF IN EYES: Rinse carefully with water for several minutes. Remove contact lenses if fitted and easy to do. Continue rinsing.
P391: Collect spillages.
P501: Dispose of contents / container in accordance with local regulations.
EUH208: Contains 2,4-D EHE. May cause an allergic reaction.
EUH401: Follow the instructions for use to avoid risks to human health and the environment.
MATTERS TO BE CONSIDERED WHEN USING AND STORING
When stored under normal (cool and dry) conditions without opening the original packaging, there is no change in the physical, chemical and biological properties of the product outside the tolerance limits for 2 years.
The manufacturers guarantee the quality of plant protection products provided that they are sold in their original packaging. The manufacturers do not accept responsibility for any damage caused by incorrect storage of their products or deficiencies in following the recommendations.
LICENSE OWNER AND MANUFACTURER COMPANY
ERTAR KİMYA Agricultural Products Tools Manufacturing Market. Singing. ve Tic. Ltd. Sti.
Acıdere Organize Sanayi Bölgesi Mahallesi Zafer Cad. No: 8 Saricam / ADANA
Tel: 0 (322) 456 19 45 Fax: 0 (322) 456 19 47
PLANT HAZARDOUS ORGANISMS FOR USING PLANT PROTECTION
|Plant Name||Harmful Organism Name||Administration dose||Time Between Last Application and Harvest|
|50 ml/da||14 day|
|60 ml/da||14 day|
|70 ml/da||14 day|
|70 ml/da||14 day|
|80 ml/da||14 day|
(*) It is not used in hybrid corn seed production and sugar corn cultivation.