PREPARATION OF PLANT PROTECTION PRODUCT FOR APPLICATION:
The plant protection product calculated over the recommended dosage is first mixed with some water in a separate container. The tank of the application machine is half filled with water. Medicated water is added to the tank while the mixer of the machine is running. The mixing is continued and the tank is completed with water. Mixing process continues until the application is completed. Use the prepared plant protection product on the same day.
Before the application, the calibration of the application machine should be done. The amount of mixture to be given to a certain area should be well adjusted in order to provide a good coating. Applications should be done in cool hours of the day in windless or less windy weather conditions.
CLEANING OF THE SPRAYING MACHINE
Empty the sprayer tank safely immediately after the application is completed. After filling the tank with clean water, run the mixer and spray system to ensure that all parts are washed. Do not wash near water sources. Do not discharge washing water and wastes into water sources.
USAGE OF PLANT PROTECTION PRODUCT
Septoria leaf spot on wheat
If the climatic conditions are appropriate for the development of the disease and there is a possibility of an epidemic situation, green component application is applied. In general, the best time to apply is the end of the scabbard period, before the flag leaf is fully opened, or before spike out. For an infection that climbs to the upper parts of the plant in the early period, it should not be expected to remove the flag leaf. Likewise, the flag leaf should not be expected for an infection in the field. Likewise, if the field is contaminated and rainy weather continues during the spiking period, it may be necessary to apply as economic damage may occur. In cases where the application needs to be repeated, the application is continued at intervals of 21-28 days.
Wheat Rust Diseases
Yellow Rust, Brown Rust, Black Rust
When symptoms of disease are seen, applications should be started. Green parts are applied against rust factors. Application should be done so that the surface of the leaves and stem is covered with the mixture. Considering the climatic conditions and disease conditions, the application is continued at intervals of 21-28 days when necessary.
Cereal powdery mildew in wheat
The course of the disease should be monitored by taking into account the climatic conditions, and in cases where the disease progresses to the upper part of the plant, the green parts should be applied in order to prevent the upper leaves, especially the flag leaf, from becoming infected with the disease.
1. Application: If combating protective fungicides is to be applied, during the period when the applications start to open before the first infections; If therapeutic fungicides are to be tackled, the fruits should be grown in chickpea size and when the leaves are fully open. In addition, therapeutic fungicides can be applied until the first symptoms appear.
2.And Other Applications: The feature of the plant protection product used is done at intervals of 15 days, taking into account the duration of action and the rainfall.
Sugar beet leaf spot disease
The first application is started when 5% of sugar beet adult leaves show cercospora leaves. It is continued with 15-20 days intervals.
Citrus brown spot
Applications are started when shoots begin to develop, taking into account the development of shoots and climate characteristics, when they are about 5-10 cm long and when the first signs of disease are seen. Applications are continued at 15-20 day intervals, especially in order to protect the newly formed parts of the growing shoots and leaves and young fruit from the disease during the development of the shoot.
The applications are terminated when the development of the shoot stops, the precipitation decreases and the temperature increases, and the fruit reaches a diameter of 4 cm.
Watermelon alternarya leaf blight
The application should start with the appearance of the first symptoms in the environment. The application is continued at 7-10 days intervals, taking into account the severity of the disease, climatic conditions and the efficacy of the plant protection product.
Corn leaf blight:
When the first signs of disease are seen, administration should be made at the specified dose.
INFORMATION ABOUT RESISTANCE
The plant protection product named DİVAX 300 EC is a fungicide classified as Group G1: 3 according to its mechanism of action. Repetitive applications of plant protection products with the same mechanism of action promote resistance development. Therefore, in order to delay the development of resistance, do not exceed the total number of applications of DİVAX 300 EC recommended in the same production season. In cases where the application should be repeated, pay attention to the use of plant protection products with a different mechanism of action (except Group G1: 3).
It can be used as a tank mixture with many commonly used plant protection products. In case of doubt, a premix test is recommended.
Rinse well by putting clean water up to ¼ in the empty packages of the product used. Pour the rinse water into the application tank. Repeat this process 3 times.
General signs of poisoning appear. Headache, dizziness, vomiting, etc.
FIRST AID MEASURES
After Inhalation: Remove patient to fresh air. If breathing is irregular or stopped, administer artificial respiration. Keep the patient in a warm and comfortable place. Contact a doctor or poison information center immediately.
After Skin Contact: Immediately take off any contaminated clothing. Wash the contacted area with plenty of water. If skin irritation persists, call a doctor. Wash contaminated clothing before use.
After Eye Contact: Immediately wash the eyes and under the eyelids with plenty of water for at least 15 minutes. Remove contact lenses, if present. Get medical attention immediately.
After Swallowing: If swallowed, seek medical advice with the product label or this safety data sheet. Do not force the patient to vomit.
ANTIDOTE and TREATMENT
It has no special antidote. Treatment is applied according to the symptoms.
HAZARDOUS EXPRESSIONS (H)
H226: Flammable liquid and vapor.
H302: Harmful if swallowed.
H312: Harmful in contact with skin.
H315: Causes skin irritation.
H317: Causes allergic skin reactions.
H318: Causes serious eye damage.
H319: Causes serious eye irritation.
H332: Harmful if inhaled.
H400: Very toxic in the aquatic environment.
H410: Long-lasting, very toxic effect in the aquatic environment.
Precautionary Statements (P)
P210: Keep away from heat. - No smoking
P273: Avoid release to the environment.
P280: Wear protective gloves / protective clothing / eye protection / face protection.
P370 + P378: In case of fire: Use water spray, carbon dioxide, foam, dry powder for extinction.
P501: Dispose of contents / container in accordance with local regulations.
EUH208: Contains Propiconazole and Alkamuls Vo / 2003. May cause an allergic reaction.
EUH401: Follow the instructions for use to avoid risks to human health and the environment.
MATTERS TO BE CONSIDERED WHEN USING AND STORING
When stored unopened in its original packaging under normal (cool and dry) conditions, there is no change in the physical, chemical and biological properties of the product for 2 years outside the tolerance limits.
The manufacturers guarantee the quality of their products provided that they are sold in their original packaging. The manufacturers do not accept responsibility for any damage caused by incorrect storage of their products or deficiencies in following the recommendations.
LICENSE OWNER AND MANUFACTURER COMPANY
ERTAR KİMYA Agricultural Products Tools Manufacturing Market. Singing. ve Tic. Ltd. Sti.
Acıdereosb Mahallesi Zafer Cad. No: 8 Saricam / ADANA
Tel: 0 (322) 456 19 45 Fax: 0 (322) 456 19 47
PLANT AND HAZARDOUS ORGANISMS TO BE USED
|Plant Name||Harmful Organism Name||Administration dose||Time Between Last Application and Harvest|
|Wheat||Septoria leaf spot
Yellow rust (Puccinia striiformis)
(Puccinia recondita tritici)
Black rust (Puccinia graminis tritici)
|Grain powdery mildew (Erysiphe graminis)||50ml/da|
|pistachios||Karazenk (Pseudocercospora pistacina)||50 ml/100 L water||21 day|
|Sugar beet||Leaf spot disease
|30 ml / da||21 day|
|Citrus||Brown spot disease
(Alternaria alterneta f.sp citri)
|50 ml/100 L water||21 day|
|Watermelon||Alternarya leaf blight
|50 ml / da||21 day|
(Bipolaris maydis, Exserohilum turcicum)
|50 ml / da||56 day|