SYNERGİZER 625 WG

* It cannot be used in vineyards where harvest leaves will be harvested.

Effect: SYNERGİZER 62.5 WG is a fungicide with systemic and contact properties. "Cyprodinil", which is one of the two active substances in the composition of the drug, prevents methionine biosynthesis; Cyprodinil is taken into the body rapidly from leaves and fruit. It is well carried upwards and from one side of the leaf to the other surface of the plant. The other active ingredient "Fludioxonil" in the drug is effective and essentially prevents germination of the conidia and penetration of the fungal micelle.

PREPARATION OF THE MEDICINE FOR APPLICATION:

Tractors, back pulverizers, motorized atomizers and any other spraying tools can be used in applications. Take care for a good coating in plants with dense green parts. Spraying should be avoided in cases where the green parts are wet during the hot hours of the day or when rain is expected immediately.

Preparation of the drug for administration: The drug calculated for a tank over the recommended dose is first mixed with a little water in a separate container. The tank of the tool is half-filled with water. Medicated water is added to the tank while the mixer of the tool is running. Continuing mixing, the remaining amount of water is put into the tank. After the drug is mixed with water, spraying is started. Mixing is continued until the application is completed.

Calibration of the Spraying Tool: Before spraying, the spraying tool's nozzles should be checked and cleaned, and the tool should work properly. Make sure that the tool is properly calibrated before spraying. To determine the amount of medicated water to be used. First, only plants in a certain area are properly wetted with water. By determining the amount of water spent, the amount of medicated water to be used per decare is calculated.

USAGE:

Lead mold in the vineyard: 1-2 applications are made with 21 days intervals during the maturing period of the grains.

Lead mold in tomato: Spraying is started when the first symptoms of the disease are seen, 2-3 applications are made at 10-12 day intervals.

Bullet mold (greenhouse) in pepper: Spraying starts when the first signs of disease are seen,

Depending on the course of the disease, 2-3 applications are made at 14 day intervals.

Lead mold in greenhouse (greenhouse): Spraying is started when the first symptoms of the disease are seen, 2-3 applications are made at 10-12 day intervals.

Cherry monilva: 1. spraying is done at the beginning of flowering (5-10% flowers), 2nd spraying is carried out in full flowering period (90-100% flowers).

Lead mold in strawberries: Spraying starts when 10% of the first flowers bloom, 2. Spraying when 50% of the flowers bloom; The third spraying should be done during the first green fruits.

Lead mold in eggplant (greenhouse): Spraying is started when the first symptoms of the disease are seen, 2-3 applications are made at 10-12 day intervals.

Plant endurance: When used as recommended, it does not have any adverse effect on cultivated plants. In case of hesitation, sensitive and new plant tolerance should be checked.

MIXTURE STATUS:

It can be mixed with most fungicides, but a miscibility test must be performed before application.